Core drill modules
-
CE1-70 Carriage Carriage CE1 for 70 mm columns. Can be used both as MD1 core drill carriage and 3P8 wire saw lower carriage. Use with PT electrical feed unit or FE1 Friction brake.
-
CEG-E-MD1 Gliding carriage for both MD1 core drill and lower carriage for 3P8 wire saw, electric feed, total ratio 2500:1. Max feed 0.8m/min.
-
CEG-M25 Gliding carriage for both MD1 core drill and lower carriage for 3P8 wire saw, manual feed, gear ratio 25:1
-
CEL-TS Carriage for line and corner drilling with TS track.
-
CER-M3-MD1 Roller type carriage for drilling with the MD1 Core drill. QDC coupling. Manual feed, ger ratio 3:1.
-
Connector w. ID-chip for MD1 Connector with ID-chip needed for the Pentpak427 if drilling with the MD1 core drill without the autofeed function.
-
ERMD1 Extension adapter Heavy duty extension adapter for Md1, type quick disconnect coupling. Extends capacity by 190 mm per adapter. Can be stacked.
-
FE1 Friction brake Friction brake for CE1-70 when used without electrical feed unit.
-
HFMR-MG41 Adapter with slip clutch for HF motors on MG41 gearbox.
-
HK-1 Hand crank for CEG and CER carriages.
-
MG41 MG41 heavy duty 4-speed gearbox for HF-motors and hydraulic motors.
-
PT-MD1 Electric feed unit Electric feed unit for MD1 core drill(43:1) for CE1-70
-
QDC - 1-1/4 Quick disconnect spindle adapter. QDC - 1-1/4" UNC
-
QDC-84 Quick disconnect spindle adapter. QDC - 84 mm P.C.D
-
QDC-94 Quick disconnect spindle adapter. QDC - 94 mm P.C.D
-
ST2-1-1/4 Spindle Unit Heavy duty spindle unit ST2, for MG41 gearbox. For upto 1000 mm or bigger drill bits. Spindle thread 1-1/4" - 7 UNC.
-
ST2-QDC Heavy duty spindle unit ST2, for MG41 gearbox. For upto 1000 mm or bigger drill bits. Spindle with quick disconnect coupling
-
ST3-1-1/4 Spindle Unit Heavy duty spindle unit ST3, for MG41 gearbox. For upto 650 mm . Spindle thread 1-1/4" - 7 UNC.
-
ST3-QDC Heavy duty spindle unit ST3, for MG41 gearbox. For upto 650 mm . Spindle with quick disconnect coupling.